Aqua Master Varnishes
Product Data Sheet
Properties
| | | | | |
| VOC gr/L | 435.00 | Volume Solids ±2% | 44.00 | Odor | dominant of paint thinner |
| VOC lbs/G | 3.63 | Weight Solids ±2% | 52.00 | Thinning | not recommended |
| |
| MPI # | G 56, SG 57 | Theor. Spread Rate | 471.0 | Weight | 7.78 |
| Gloss 60° | G 95, SG 40, S 4 | Wet Film Thickness | 4 mils | Viscosity | 63 - 67 Krebs Units |
| Sheen 85° | | Dry Film Thickness | 1.5 mils | Resistance | excellent |
| |
| Tinting Type | | Toxic Properties | Non-toxic as dry film | Cleanup | 799250x Mineral Thinner |
| Local Harvest | | Light Reflectance | None | Packaging | quart & single gallons |
| |
| | | | | |
| |
| | | | | |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
Dry Times
At 77 degrees Fahrenheit and 50% Relative Humidity.
| | | | | |
| Dry To Touch | 2 ½ hours | Dry To Sand | 16 hours | Tack Free | 2 1/2 hours |
| Dry To Recoat | 16 hours | Dry To Topcoat | N/A | Dry To Hard | 48 hours |
Prep & Prime
Surfaces to be coated must be free of dirt, oil, mildew, excessive chalk and other foreign matter. remove loose paint and patch holes or cracks. Prime bare surfaces, dull or prime glossy surfaces, and then scuff sand using 80 to 100 grit sandpaper on a hand sander. Remove all sanding dust.
| |
| |
| |
| |
| |
| Wood | All new wood should be sealed with 705100 Quick Dry Sanding Sealer and lightly sanded before applying finish coats. Porous wood such as mahogany, etc., should be grain filled with paste wood filler before sealing. Two finish coats as a minimum is recommended for best exterior performance. |
| |
Application
Do not apply when air or surface temperatures are expected to drop below 50º F. or rise above 95º F. during application and drying.
| |
| |
| Brush | Use a top quality natural bristle brush or nylon/polyester brush |
| Roller / Pad | Use 3/16" to 3/8" nap synthetic or lambswool roller cover.-Use a top quality synthetic pad. |
| Airless Spray | Use equipment capable of constant 1850 psi at tip. An .013" to .107" tip orifice is recommended. |
| |
| Conventional Spray | DeVilbiss JGA gun or equivalent is recommended. Fluid pressure of 20 lbs.; atomizing pressure; 35 - 40 psi. |
Corporate: 6107 N Marine Drive Portland, Oregon 97203 - Rodda Paint Co. - Regional: 3838 4th Avenue South Seattle, Washington 98134
Disclaimer - All technical advice, recommendations and services regarding this product are rendered by the Seller gratis. They are based on technical data which the Seller believes to be reliable and are intended for use by persons having skill and know-how, at their discretion and risk. Seller assumes no responsibility for results obtained or damages incurred from this product use by Buyer whether as recommended herein or otherwise. Such recommendations, technical advice or services are not to be taken as a license to operate under or suggest infringement of any patent.
Last Modification Date: 11/11/2011 - Please contact us at 800.452.2315 for additional information or questions
