Polycoat High Solids Satin
Product Data Sheet
| | | |
| Description | A PIGMENTED HIGH SOLIDS TWO COMPONENT ACRYLIC URETHANE ENAMEL |
729301x White Base
729303x Deep Base
729304x Neutral Base
Part B Converter: 732287x | |
|
| Basic Use | A two component satin sheen coating that combines the appearance of a high quality enamel and the performance of a chemically cured coating. Protects and beautifies transportation vehicles, storage tanks, structural steel, metal siding, walls, etc. |
| |
| Pot Life | 2 hours at 77 degrees Fahrenhe | | |
| | | |
| Induction | No induction time is required | Mixing Instructions | Pre mix Part A to insure all material is in suspension, then add Part B. Ratio |
Properties
| | | | | |
| VOC gr/L | 362.00 | Volume Solids ±2% | 60.00 | Odor | sharp of Ketone/aromatic |
| VOC lbs/G | 3.02 | Weight Solids ±2% | 72.50 | Thinning | If, up to 10% maximum |
| |
| MPI # | | Theor. Spread Rate | 642.0 | Weight | 10.90 |
| Gloss 60° | 40-50 | Wet Film Thickness | 3.25 mils | Viscosity | 75-85 Krebs Units |
| Sheen 85° | | Dry Film Thickness | 1.5 mils | Resistance | |
| |
| Tinting Type | opti xp | Toxic Properties | None as dried film | Cleanup | MIBK, MEK, or 732322x |
| Local Harvest | | Light Reflectance | Will vary with color | Packaging | As desired |
| |
| | | | | |
| |
| | | | | |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
Dry Times
| | | | | |
| Dry To Touch | 1 to 2 hours. | Dry To Sand | | Tack Free | |
| Dry To Recoat | 12 hours. | Dry To Topcoat | | Dry To Hard | |
Prep & Prime
| |
| |
| Masonry | May be used satisfactorily on these surfaces when proper surface preparation and priming is completed. |
| Metal | Non-ferrous: Must be treated with Galva Prep or similar type etching material.
Ferrous: Must have all mill scale, rust, dirt, grease, etc., removed. Prime with a suitable primer such as Ropon 709095 Primer prior to topcoating. |
| |
| |
| |
Application
| |
| |
| |
| |
| Airless Spray | Equipment capable of maintaining constant 1800 psi at the tip. Use a .013" to .019" tip orifice. |
| |
| Conventional Spray | DeVilbiss JGA Gun or equivalent. Fluid pressure 25-30 psi; pressure 40-50 psi. |
Corporate: 6107 N Marine Drive Portland, Oregon 97203 - Rodda Paint Co. - Regional: 3838 4th Avenue South Seattle, Washington 98134
Disclaimer - All technical advice, recommendations and services regarding this product are rendered by the Seller gratis. They are based on technical data which the Seller believes to be reliable and are intended for use by persons having skill and know-how, at their discretion and risk. Seller assumes no responsibility for results obtained or damages incurred from this product use by Buyer whether as recommended herein or otherwise. Such recommendations, technical advice or services are not to be taken as a license to operate under or suggest infringement of any patent.
Last Modification Date: 4/15/2009 - Please contact us at 800.452.2315 for additional information or questions
