Exterior Control Wood Primer
Product Data Sheet
Properties
| | | | | |
| VOC gr/L | 303.00 | Volume Solids ±2% | 61.00 | Odor | mild of mineral spirits |
| VOC lbs/G | 2.53 | Weight Solids ±2% | 79.00 | Thinning | do not thin |
| |
| MPI # | 5 & 7 | Theor. Spread Rate | 652.0 | Weight | 11.90 |
| Gloss 60° | 0-10 | Wet Film Thickness | 2 mils | Viscosity | 78 - 83 Krebs Units |
| Sheen 85° | | Dry Film Thickness | 1.5 mils | Resistance | |
| |
| Tinting Type | universal, opti xp | Toxic Properties | Non-toxic as dry film | Cleanup | 799250x mineral spirits |
| Local Harvest | | Light Reflectance | white 85%, less on tints | Packaging | single & five gallons |
| |
| | | | | |
| |
| | | | | |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
Dry Times
At 77 degrees Fahrenheit and 50% Relative Humidity.
| | | | | |
| Dry To Touch | 2 to 4 hours | Dry To Sand | N/A | Tack Free | 2 to 4 hours |
| Dry To Recoat | 24 to 48 hours | Dry To Topcoat | 24 to 48 hours | Dry To Hard | N/A |
Prep & Prime
Surfaces to be coated must be free of dirt, oil, mildew, excessive chalk and other foreign matter. Remove loose paint and patch holes or cracks. Prime bare surfaces, dull or prime glossy surfaces, and then scuff sand using 80 to 100 grit sandpaper on a hand sander. Remove all sanding dust.
| |
| |
| Masonry | Not intended for masonry surfaces, but may be used satisfactorily. |
| Metal | Not intended for metal, but may be used over metallic surfaces that have been properly pre-primed. |
| |
| Wood | New wood must be dry, clean and free of any loose material before painting. Surfaces being repainted must be free of all loose, scaling, peeling, heavily chalking material prior to repainting. |
| |
Application
Do not apply when air or surface temperatures are expected to drop below 50 degrees F. or rise above 95 degrees F. during application and drying.
| |
| |
| Brush | Use a top quality natural bristle brush or nylon/polyester brush |
| Roller / Pad | Use 1/4" to 3/4" nap synthetic roller cover. |
| Airless Spray | Use an .011 to .019 tip and 1700 psi maximum. |
| |
| Conventional Spray | Use DeVilbiss JGA gun or equivalent. Fluid pressure of 10 psi and atomizing pressure of 30 - 35 psi. |
Corporate: 6107 N Marine Drive Portland, Oregon 97203 - Rodda Paint Co. - Regional: 3838 4th Avenue South Seattle, Washington 98134
Disclaimer - All technical advice, recommendations and services regarding this product are rendered by the Seller gratis. They are based on technical data which the Seller believes to be reliable and are intended for use by persons having skill and know-how, at their discretion and risk. Seller assumes no responsibility for results obtained or damages incurred from this product use by Buyer whether as recommended herein or otherwise. Such recommendations, technical advice or services are not to be taken as a license to operate under or suggest infringement of any patent.
Last Modification Date: 6/2/2011 - Please contact us at 800.452.2315 for additional information or questions
