Black Dipping Enamel-Low Gloss
Product Data Sheet
Properties
| | | | | |
| VOC gr/L | 89.00 | Volume Solids ±2% | 23.50 | Odor | Mild dominant odor of ammonia. |
| VOC lbs/G | 0.74 | Weight Solids ±2% | 28.90 | Thinning | None recommended. If necessar |
| |
| MPI # | | Theor. Spread Rate | 0.0 | Weight | 8.80 |
| Gloss 60° | 18-22 | Wet Film Thickness | | Viscosity | 55-60 Krebs Units or 19-23 sec |
| Sheen 85° | | Dry Film Thickness | | Resistance | |
| |
| Tinting Type | | Toxic Properties | None as dry film. Use with ad | Cleanup | Immediately clean with warm, s |
| Local Harvest | | Light Reflectance | | Packaging | |
| |
| | | | | |
| |
| | | | | |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
Dry Times
| | | | | |
| Dry To Touch | 15 to 30 minutes | Dry To Sand | | Tack Free | |
| Dry To Recoat | One hour. | Dry To Topcoat | | Dry To Hard | 8 hours. |
Prep & Prime
All surfaces to be painted must be clean and dry. Remove all rust, dirt, grease, cutting oil,etc.,prior to painting. Do not apply to surfaces at less than 50 degrees Fahrenheit surface temperature. Do not expose freshly painted surfaces to atmospheric conditions until film is thoroughly cured.
| |
| |
| |
| Metal | Can be applied directly to steel, galvanize, and aluminum in most cases, but for difficult aluminum surfaces, application of No. 709700 Vinyl Wash Primer is recommended.
Excessive reduction with water may cause flash rusting on steel. |
| |
| |
| |
Application
At 77 degrees Fahrenheit and 50% Relative Humidity.
Corporate: 6107 N Marine Drive Portland, Oregon 97203 - Rodda Paint Co. - Regional: 3838 4th Avenue South Seattle, Washington 98134
Disclaimer - All technical advice, recommendations and services regarding this product are rendered by the Seller gratis. They are based on technical data which the Seller believes to be reliable and are intended for use by persons having skill and know-how, at their discretion and risk. Seller assumes no responsibility for results obtained or damages incurred from this product use by Buyer whether as recommended herein or otherwise. Such recommendations, technical advice or services are not to be taken as a license to operate under or suggest infringement of any patent.
Last Modification Date: 4/17/2009 - Please contact us at 800.452.2315 for additional information or questions
